Remove any protective strippable film before fixing the next panel. Place the first panels female rib over the lip of the edge trim and when engaged, lay the panel flat on the covered plywood.įit the clips to the male rib as per the details mentioned above, making sure they are square with no sharp edges protruding and screws fully tightened. Install a starter edge trim before attempting to fix the first panel. Make sure that all the laps are from the top run over the lower run so any moisture will run into the gutters. Proceed to lay further runs up the roof pitch until the whole of the plywood is covered. Starting from the lowest part of the roof, lay across the roof plywood an anti-abrasive membrane.
0 kommentar(er)
